Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Cable Adjustment - Shift

With the gearshift lever (7210) in the PARK position, loosen the transmission range switch cable nut.

Fig 1: Loosening Transmission Range Switch Cable Nut
Courtesy of FORD MOTOR CO.
Manually move the shift cable rearward as far as possible.

Fig 2: Moving Shift Cable Rearward
Courtesy of FORD MOTOR CO.
Check the cable for any tension or restriction of movement and then tighten the transmission range switch cable nut to specification.

Fig 3: Tightening Transmission Range Switch Cable Nut

Courtesy of FORD MOTOR CO.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.