Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Oil Pan: Installation
- Clean and inspect the mounting faces of both the oil pan and the cylinder block. To remove all traces of previous sealer, use solvent to clean the cylinder block and oil pump. Both surfaces must be flat, clean and dry.
- Apply a 3 mm (0.1 inch) continuous bead of silicone gasket and sealant to the oil pan.
- Install the oil pan. Tighten the bolts from the middle out as shown in Fig 1.
- Install the catalytic convertor. For additional information, refer to INSTALLATION .
- Install the oil pan drain plug (6730).
- Lower the vehicle.
- Fill the crankcase with clean engine oil.
CAUTION:
Do not use abrasive grinding discs to remove gasket material; use only manual scrapers. Do not scratch or gouge the aluminum sealing surfaces.
NOTE:
Install the oil pan within four minutes after the sealant has been applied.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
