Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Motors
MOTORS LOCATION
| Component | Location |
|---|---|
| Adjustable Pedal Motor | Under left side of dash, on accelerator pedal support. |
| Auxiliary Blower Motor | Behind panel, left of rear seat. |
| Electric Cooling Fan Motor No. 1 | Behind left side of radiator. See Figure . |
| Electric Cooling Fan Motor No. 2 | Behind right side of radiator. See Figure . |
| Front Blower Motor | Behind right side of dash. See Figure . |
| Left Sliding Door Lock Actuator Assembly | In sliding door. |
| Liftgate Lock Actuator | In liftgate. See Figure . |
| Mode Door Actuator (Rear) | Left of rear seat. |
| Power Sliding Door Motor (Left) | In left quarterpanel. |
| Power Sliding Door Motor (Right) | In right quarterpanel. |
| Rear Window Washer Pump Motor | At right side of engine compartment, in washer fluid reservoir. See Figure . |
| Rear Wiper Motor Assembly | Inside liftgate. See Figure . |
| Right Sliding Door Lock Actuator | In sliding door. See Figure . |
| Speed Control Servo | At left side of engine compartment. See Figure . |
| Temperature Blend Door Actuator | Behind right side of dash. See Figure . |
| Windshield Washer Pump Motor | In washer fluid reservoir. See Figure . |
| Windshield Wiper Motor | At left rear side of engine compartment. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
