Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Instrument Cluster And Panel Illumination DTCS
INSTRUMENT CLUSTER MODULE (ICM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action/Go to |
|---|---|---|---|
| B1205 | IC Switch 1 Assembly Circuit Failure (Open or Short to Battery) | ICM | INFORMATION AND MESSAGE CENTER |
| B1213 | Anti-Theft Number of Programmed Ignition Keys Is Below Minimum | ICM | ANTI-THEFT - PATS |
| B1232 | Antenna Not Connected/Defective Transceiver | ICM | ANTI-THEFT - PATS |
| B1246 | Dim Panel Potentiometer Switch Circuit Failure | ICM | PINPOINT TEST E |
| B1249 | Blend Door Failure | ICM | CLIMATE CONTROL SYSTEM-GENERAL INFORMATION |
| B1342 | ECU Defective | ICM | CLEAR and DOCUMENT the DTCs. CARRY OUT the instrument cluster Self-Test. INSTALL a new instrument cluster if DTC B1342 is retrieved again. Refer to INSTRUMENT CLUSTER . |
| B1346 | Heated Backlite Input Circuit Short to Ground. | ICM | GLASS, FRAMES AND MECHANISMS |
| B1352 | Ignition Key-In Circuit Failure. | ICM | WARNING DEVICES |
| B1470 | Lamp Headlamp Input Circuit Failure. | ICM | EXTERIOR LIGHTING |
| B1600 | PATS Ignition Key Transponder Signal Is Not Received - Damaged Key or Non-PATS Key | ICM | ANTI-THEFT - PATS |
| B1601 | PATS Received Incorrect Key-Code From Ignition Key Transponder (Unprogrammed Encoded Ignition Key) | ICM | ANTI-THEFT - PATS |
| B1602 | PATS Received Invalid Format of Key-Code From Ignition Key Transponder (Partial Key Read) | ICM | ANTI-THEFT - PATS |
| B1676 | Battery Voltage Out of Range | ICM | INSTRUMENT CLUSTER |
| B1681 | PATS Transceiver Signal Is Not Received (Not Connected, Damaged, or Wiring) | ICM | ANTI-THEFT - PATS |
| B1875 | Turn Signal/Hazard Switch Signal Circuit Failure | ICM | EXTERIOR LIGHTING |
| B2139 | PCM ID Does Not Match Between IC and PCM | ICM | ANTI-THEFT - PERIMETER |
| B2141 | NVM Configuration Failure (No PCM ID Exchanged Between IC and PCM) | ICM | ANTI-THEFT - PATS |
| B2175 | A/C Request Signal Circuit Short to Ground | ICM | CLIMATE CONTROL SYSTEM-GENERAL INFORMATION |
| B2176 | Overdrive Switch Circuit Short to Vbatt | ICM | TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS |
| B2472 | Fog Lamp Switch Failure | ICM | EXTERIOR LIGHTING |
| B2477 | Module Configuration Failure | ICM | MODULE CONFIGURATION |
| B2513 | Blower (Fan) Circuit Failure | ICM | CLIMATE CONTROL SYSTEM-GENERAL INFORMATION |
| B2586 | Headlamp Mode Circuit Failure | ICM | EXTERIOR LIGHTING |
| C1779 | Blower Switch Failure | ICM | CLIMATE CONTROL SYSTEM-GENERAL INFORMATION |
| U1041 | SCP (J1850) Invalid or Missing Data for Vehicle Speed | PCM | CARRY OUT the PCM self-test. |
| U1043 | SCP (J1850) Invalid or Missing Data for Traction Control | ABS/TC | CARRY OUT the ABS/TC self-test. |
| U1051 | SCP (J1850) Invalid or Missing Data for Brakes | ABS/TC | CARRY OUT the ABS/TC self-test. |
| U1073 | SCP (J1850) Invalid or Missing Data for Engine Coolant | PCM | CARRY OUT the PCM self-test. |
| U1123 | SCP (J1850) Invalid or Missing Data for Odometer | ABS/TC | CARRY OUT the ABS/TC self-test. |
| U1131 | SCP (J1850) Invalid or Missing Data for Fuel System | REM | INSTRUMENT CLUSTER |
| U1147 | Invalid or Missing Data for Vehicle Security | PCM/J1850 | ANTI-THEFT - PATS |
| U1262 | Missing SCP Message | J1850 | MODULE COMMUNICATIONS NETWORK |
| U2013 | Compass Module - No Response | ICM | INFORMATION AND MESSAGE CENTER |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
