2003 Ford Taurus SES, 3.0 U, AX4SFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2003 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
General Specifications Table (1 Of 2)

Item Specification
Heat shrink tube overlap mm (inch) 12.7 (0.5)
Wire insulation removal length (twist side) mm (inch) 37.2 (1.5)
General Specifications Table (2 Of 2)

Item Specification
Wire insulation removal length (receiving side) mm (inch) 19.5 (0.75)
Raychem SCT® Heat Shrink Tubing, Motorcraft part number WT-5627 ESB-M99D56-A2
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.