Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Taurus LX, 3.0 UFACTORY OEM SERVICE PROCEDURE
Power Windows DTCS
POWER WINDOWS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Perform Test |
|---|---|---|---|
| B1302 | Accessory Delay Relay Coil Circuit Failure | GEM | If the accessory delay feature is inoperative, Go To PINPOINT TEST F
. If the accessory delay feature does not turn off, Go To PINPOINT TEST E . |
| B1304 | Accessory Delay Relay Coil Circuit Short to Battery | GEM | Go To PINPOINT TEST F . |
| B1345 | Heated Backlite Input Circuit Short to Ground | GEM | Go To PINPOINT TEST C . |
| B1347 | Heated Backlite Relay Circuit Failure. | GEM | If the rear window does not defrost, Go To PINPOINT TEST C
. If the rear window defrost does not turn off, Go To PINPOINT TEST D . |
| B1349 | Heated Backlite Relay Short to Battery | GEM | Go To PINPOINT TEST C . |
| B1398 | Driver Power Window One-Touch Window Relay Circuit Failure | GEM | If only the one-touch down feature is inoperative, Go To PINPOINT TEST B
. If the driver front window is inoperative, Go To PINPOINT TEST A . |
| B1400 | Driver Power Window One-Touch Window Relay Circuit Short to Battery | GEM | Go To PINPOINT TEST B . |
| B1405 | Driver Power Window Down Circuit Short to Battery | GEM | Go To PINPOINT TEST B . |
| B1408 | Driver Power Window Up Circuit Short to Battery | GEM | Go To PINPOINT TEST A . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
