2003 Ford Focus L4-2.3L VIN ZFACTORY OEM SERVICE PROCEDURE

Spark Plug: Service and Repair

REMOVAL
1. Remove the ignition coil.


Factory service manual diagram





2. Remove the spark plug.


NOTE: Remove foreign material with compressed air.


Factory service manual diagram





3. Inspect the spark plugs.


Factory service manual diagram





4. Check and adjust the spark plug gap as necessary.

INSTALLATION
1. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.