2003 Ford Explorer 4.0 K, AWDFACTORY OEM SERVICE PROCEDURE

Cruise Control DTCS

NOTE: DTC P0703 and DTC P1572 must be repaired before any other DTC.
SPEED CONTROL ACTUATOR DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTCs Description Source Action
P0500 Vehicle Speed Error PCM REFER to SELF-DIAGNOSTICS - CNG, FLEX-FUEL & GASOLINE .
P1565 Speed Control Command Switches High/Out of Range PCM Go To PINPOINT TEST A .
P1566 Speed Control Command Switches Low/Out of Range PCM Go To PINPOINT TEST B .
P1567 Speed Control Output Circuit PCM Go To PINPOINT TEST C .
P1568 Speed Control Unable to Hold Speed PCM Go To PINPOINT TEST D .
P1572 Brake On/Off Failure PCM Go To PINPOINT TEST E .
P0703 Brake Switch Input Malfunction PCM Go To PINPOINT TEST E .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.