Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Excursion 2WD V8-6.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Technical Service Bulletins
- Recalls
- Customer Interest
- Fuel System - Hard/No Start/Runs Rough
- Engine Controls - ECM Update For Various Issues/DTC's
- Diesel Engine - Low Power/Exhaust Smoke/Surging
- Engine Controls - Low Power/Surge/Flutter/Multiple DTC's
- Emissions - Low Power/Smoke/EGR DTC's Set
- Engine Controls - Low Power/Surge/Rough Idle/Smoke
- A/T Controls - MIL ON/DTC's Set After A/T R and R
- Engine Controls - Diesel Engine Driveability Concerns
- Diesel Engine - Hard or No Start Condition
- Engine, A/T Controls - Erratic A/T Shifting Over 50 MPH
- By Symptom
- Customer Interest
- Fuel System - Hard/No Start/Runs Rough
- Engine Controls - ECM Update For Various Issues/DTC's
- Diesel Engine - Low Power/Exhaust Smoke/Surging
- Engine Controls - Low Power/Surge/Flutter/Multiple DTC's
- Emissions - Low Power/Smoke/EGR DTC's Set
- Engine Controls - Low Power/Surge/Rough Idle/Smoke
- A/T Controls - MIL ON/DTC's Set After A/T R and R
- Engine Controls - Diesel Engine Driveability Concerns
- Diesel Engine - Hard or No Start Condition
- Engine, A/T Controls - Erratic A/T Shifting Over 50 MPH
- Driveability
- Erratic Shifting
- False instrument warning light/gauges
- High emissions
- Odors
- Poor performance
- Recalls
- Smoke, Fumes
- Starting problems
- Customer Interest
- All Technical Service Bulletins
- Fuel System - Hard/No Start/Runs Rough
- Engine Controls - ECM Update For Various Issues/DTC's
- Diesel Engine - Various Driveability/Starting Issues
- Diesel Engine - Low Power/Exhaust Smoke/Surging
- Engine Controls - Low Power/Surge/Flutter/Multiple DTC's
- Emissions - Low Power/Smoke/EGR DTC's Set
- Recall - Module Reflash for OBD Improvements
- Engine Controls - Low Power/Surge/Rough Idle/Smoke
- A/T Controls - MIL ON/DTC's Set After A/T R and R
- Engine Controls - MIL ON/Lean DTC Service Tips
- Engine Controls - WDS Power Balance Test Service Tip
- Recall - Program PCM to Interface with Generic Scanner
- Campaign - Cold Weather Performance Enhancement
- Engine Controls - Diesel Engine Driveability Concerns
- Diesel Engine - Hard or No Start Condition
- Engine, A/T Controls - Erratic A/T Shifting Over 50 MPH
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
