2003 Ford Excursion 2WD V8-6.0L DSL TurboFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair

REMOVAL
1. Remove the air conditioning compressor.


Factory service manual diagram





2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.


Factory service manual diagram





3. Remove the bolt and the CKP sensor.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Apply clean engine oil to the O-ring before installation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.