Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Excursion 2WD V8-6.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Air Flow Meter/Sensor: Description and Operation
Mass Air Flow Sensor
Mass Air Flow (MAF) Sensor:
Note: Moisture or other contamination of the MAF sensing element can cause incorrect air flow input to the PCM resulting in EGR or VGT DTC's.
The mass air flow (MAF) sensor provides an analog voltage signal to the PCM proportional to the intake air mass. The MAF sensor utilizes a hot wire sensing element to measure the amount of air entering the engine. The hot wire is maintained at 200°C (392°F) above ambient temperature. Air passing over the hot wire cools the wire. The current required to maintain the temperature of the hot wire is proportional to the air mass flow. The MAF signal is used for exhaust pressure calculator and exhaust gas recirculation (EGR) diagnostics.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
