2003 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE

Connecting Rod, Engine

Connecting Rod
Big End Journal Inside Diameter with Assembled Liners 53.049 - 53.027 mm
Rod Bearing to Journal Clearance 0.064 - 0.026 mm
Pin Bore Diameter (Rod) 22.024 - 22.012 mm

Factory service manual diagram




NOTE: Be sure to tighten the bolts in two stages.

Tighten the connecting rod bolts in the sequence shown.
^ Stage 1: Tighten to 43 Nm (32 ft. lbs.).
^ Stage 2: Tighten an additional 105 degrees.
Rotate the crankshaft and repeat the procedure to position each connecting rod at bottom dead center until all bolts are tightened to specification.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.