Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Escape 2.0 BFACTORY OEM SERVICE PROCEDURE
Toe-In Adjustment: Rear
NOTE:
Jounce the vehicle to make sure that the suspension is in its normal resting position.
- Check the toe setting using suitable wheel alignment equipment. Loosen the left and right rear suspension trailing arm and bushing bolt. See Fig 1 .
- Turn the left and right adjusting cams simultaneously until the toe is within specification. See Fig 2 . See WHEEL ALIGNMENT SPECIFICATIONSΒ .
- Tighten the left and right rear suspension trailing arm and bushing bolts to specification. See TORQUE SPECIFICATIONSΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
