Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford Escape 2.0 BFACTORY OEM SERVICE PROCEDURE
Wiper/Washer Systems DTCS
WIPER/WASHER SYSTEM (GEM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Action/Go To |
|---|---|---|---|
| B1244 | Wiper Rear Motor Run Relay Circuit Failure | GEM | If the rear window wipers are inoperative, Go to PINPOINT TEST G
. If the rear window wipers stay on continuously, Go to PINPOINT TEST H . |
| B1245 | Wiper Rear Motor Run Relay Circuit Short to Battery | GEM | Go to PINPOINT TEST G . |
| B1342 | GEM is Defective | GEM | CLEAR the DTC. REPEAT the GEM self-test. INSTALL a new GEM. REFER to MULTIFUNCTION ELECTRONIC MODULE . |
| B1611 | Wiper Rear Mode Select Switch Circuit Failure | GEM | Go to PINPOINT TEST H . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.