2003 Ford Escape 2.0 BFACTORY OEM SERVICE PROCEDURE

Multifunction Electronic Module: Notes

Refer to SYSTEM WIRING DIAGRAMS article for schematic and connector information.

SPECIAL TOOL(S)Β 

Fig 1: Special Tool
G01388800Courtesy of FORD MOTOR CO.

For rear wiper/washer control and interval timer concerns, refer to WIPERS AND WASHERS .

For interior lamps/illuminated entry and battery saver concerns, refer to INTERIOR LIGHTING .

For auto headlamp concerns, refer to EXTERIOR LIGHTING .

For keyless entry/power door lock concerns, refer to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .

For accessory delay concerns, refer to GLASS, FRAMES AND MECHANISMS .

For perimeter anti-theft concerns, refer to ANTI-THEFT - PERIMETER .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.