2002 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Fuel Pump Driver Module (FPDM): Removal

WARNING: This page is about a different car, the 2004 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull up the rear seat.
  2. Position the floor covering to one side.
  3. Remove the fuel pump driver module (FPDM).
    1. Disconnect the FPDM electrical connector.
    2. Remove the FPDM.
    Fig 1: Removing Fuel Pump Driver Module (FPDM)
    G03192170Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.