Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Camber Adjustment: Front
- Top mounting studs on front struts are offset. Measure camber and caster. See WHEEL ALIGNMENT SPECIFICATIONSΒ . Camber is adjusted by rotating strut. See CAMBER/CASTER POSITION REFERENCE (FRONT)Β table. Lift vehicle to unload suspension.
- Remove top strut attaching nuts. Lower strut, and rotate strut bearing to desired position. Reinstall strut into tower. Install and tighten nut to specification. Tighten nuts to specification. See TORQUE SPECIFICATIONSΒ .
CAMBER/CASTER POSITION REFERENCE (FRONT)
| Adjustment Mark (1) | Camber Angle - Degrees | (2) Caster Angle - Degrees | ||||
|---|---|---|---|---|---|---|
| A | 0.23 | 0.23 | ||||
| B | 0.48 | 0 | ||||
| C | 0.23 | - 0.23 | ||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
