2002 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Step B

WARNING: This page is about a different car, the 2004 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press trigger.
  2. If the NGS asks for vehicle data - enter the vehicle data then press store.
  3. The NGS will ask for module data line 1 - enter data and press store.
  4. The NGS will then ask if there is an additional line of data available for that address - Select YES or NO depending on the information in the As Built Data Sheet.
  5. Repeat Steps 3 and 4 until the answer is NO for Step 4.
  6. The NGS should show a screen stating that module data was stored - press trigger.
  7. Follow the on-screen instructions.
  8. SELECT: Restore Configuration - New ECU then press trigger.
  9. The NGS will complete loading the entered data.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.