Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed Control Switches
The speed control system is operated by means of five switches on the steering wheel. The functions are:
| Switch | Function |
|---|---|
| ON | Activate system |
| OFF | Deactivate system |
| + (SET/ACC) | Set/Accelerate and tap up |
| - (COAST) | Coast and tap down |
| = (RESUME) | Resume |
When the ON switch is pressed and the vehicle is travelling at a speed greater than 48 km/h (30 mph) the speed control actuator will accept speed inputs.
The + (SET/ACC) switch is used to set or accelerate the vehicle at speeds above 48 km/h (30 mph). The switch can be used in three ways.
- Accelerate the vehicle with the accelerator pedal to the required speed, press and release the + (SET/ACC) switch, the vehicle will then maintain the required speed.
- Press the + (SET/ACC) switch and hold it down until the vehicle reaches the required speed. When released, the speed is stored in the memory and used to maintain the vehicle speed.
- Press the + (SET/ACC) switch repeatedly in order to increase the vehicle speed by increments of 1.6 km/h (1 mph).
The - (COAST) switch is used to reduce vehicle speed. The switch can be used in two ways:
- Press and hold the - (COAST) switch down until the vehicle slows to the required speed. When the switch is released, the speed is stored in the memory and used to maintain the vehicle speed.
- Press the - (COAST) switch repeatedly to reduce the vehicle road speed by increments of 1.6 km/h (1 mph).
Pressing the = (RESUME) switch returns the vehicle to the set speed when speed control is in the stand-by mode. Pressing and releasing the = (RESUME) switch at any speed greater than 48 km/h (30 mph) will return the vehicle to the previous set speed.
Pressing the OFF switch deactivates the speed control system. The speed setting stored in memory will be erased.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.