2002 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE

Intake Manifold

WARNING: This page is about a different car, the 2003 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Made up of two assemblies replacing the single piece manifold with fixed length tracts.

  • Plenum Assembly
  • Housing Assembly-Manifold-Injectors
  • Variable-length intake runner design.

The unit is in the short runner position with the engine off and then switches to the long runner position when the engine starts. The runners then switch to short runner position above 6000 rpm.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.