Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| Brake caliper hose bolt | 22 | 16 |
| Catalytic converter support bracket bolts | 20 | 15 |
| Catalytic converter support bracket nuts | 23 | 17 |
| Damper fork bolt | 109 | 80 |
| Front lower control arm inner bolt | 110 | 81 |
| Front wheel hub nut | 255 | 185 |
| Halfshaft support bracket bolts | 55 | 41 |
| Intermediate shaft bearing support bolts | 40 | 30 |
| Lower arm ball joints nuts | 200 | 148 |
| Lower control arm bolt and nut | 103 | 76 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
