Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford ZX2 AutomaticFACTORY OEM SERVICE PROCEDURE
Component Testing Procedure
WARNING: This page is about a different car, the 2006 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH, LAMP PORTION COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| High beam | 9 and 10 | High beam | Closed circuit |
| Flash-to-pass | Open circuit | ||
| Low beam | Open circuit | ||
| Low beam/Flash-to-pass | 9 and 12 | High beam | Open circuit |
| Flash-to-pass | Closed circuit | ||
| Low beam | |||
| 11 and 10 | High beam | Open circuit | |
| Flash-to-pass | Closed circuit | ||
| Low beam | Open circuit | ||
| Cornering lamp | 9 and 1 | Left turn | Closed circuit |
| Off | Open circuit | ||
| 9 and 3 | Right turn | Closed circuit | |
| Off | Open circuit |
MULTIFUNCTION SWITCH, LAMP PORTION COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 1, C202c and 2, C202c | Left turn, Hazard Off | Closed circuit |
| 1, C202c and 2, C202a | |||
| 4, C202c and 5, C202c | |||
| 4, C202c and 5, C202c | Right turn, Hazard Off | Closed circuit | |
| 1, C202c and 5, C202c | |||
| 1, C202c and 3, C202c | |||
| Hazard | 6, C202c and 10, C202c | Hazard On, Turn signal switch in neutral | Closed circuit |
| 1, C202c and 2, C202c | |||
| 1, C202c and 2, C202a | |||
| 1, C202c and 5, C202c | |||
| 1 C202c and 3, C202c | |||
| Stoplamps | 9, C202c and 10, C202c | Hazard Off, Turn signal switch in neutral | Closed circuit |
| 4, C202c and 2, C202a | |||
| 4, C202c and 5, C202c |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.