2002 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE

General Specifications

GENERAL SPECIFICATIONS

Item Specification
Front Ride Height 
Front 59 mm (2.36 in) +/- 8.4 mm (0.33 in.)
Rear Ride Height 
Rear 165 mm (6.6 in.) +/- 12 mm (0.48 in.)
Ball Joint Deflection 
Lower 0-0.4 mm (0-0.016 in)
Dogtracking 
Maximum 20 mm (0.8 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.