Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
ALIGNMENT SPECIFICATIONS
| Item | LH | RH | Total/Split |
|---|---|---|---|
| Front | |||
| Camber | -0.44° +/- 0.5° | -0.44° +/- 0.5° | 0° +/- 0.5° |
| Caster | 3.3° +/- 0.75° | 3.8° +/- 0.75° | -0.5° +/- 0.5° |
| Toe (positive value is toe-in, negative value is toe-out) | - | - | -0.15° +/- 0.25° |
| Rear | |||
| Camber | -0.1° +/- 0.5° | -0.1° +/- 0.5° | - |
| Caster | - | - | - |
| Toe (positive value is toe-in, negative value is toe-out) | - | - | 0.06° +/- 0.34° |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.