2002 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Anti-Lock Brake Control Module Under vehicle, attached to hydraulic control unit.
Compass Module Center front underside of ceiling.
Front Electronic Module (FEM) Below left side of dash. See Figure.
Parking Aid Module (PAM) Right rear of vehicle.
Passive Anti-Theft System (PATS) Transceiver Module On steering column. See Figure.
Power Sliding Door Module (Left) In left rear quarter panel.
Power Sliding Door Module (Right) In right rear quarter panel.
Powertrain Control Module (PCM) Behind right side of dash, through firewall. See Figure.
Rear Electronic Module (REM) At right rear quarter panel. See Figure.
Rear Seat Entertainment Module In rear seat entertainment console.
Remote Keyless Entry (RKE) Module Behind right side of dash. See Figure.
Restraint Control Module (RCM) Behind left side of dash. See Figure.
Trailer Tow Module On right "D" pillar.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.