Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Taurus LX, 3.0 2, AX4SFACTORY OEM SERVICE PROCEDURE
Test H: No Module/Network Communication
WARNING: This page is about a different car, the 2002 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform all voltage and resistance tests using a Digital Volt-Ohm Meter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.
- Turn ignition switch to LOCK position. Inspect Worldwide Diagnostic System (WDS) tester or New Generation Star (NGS) tester connector for loose, damaged or corroded terminals. If connector terminals are faulty, repair or replace as necessary. If connector terminals are okay, go to next step.
- Inspect Data Link Connector (DLC) for loose, damaged or corroded terminals. See Figure. DLC is located under instrument panel between steering column and the radio. See Figure. If connector terminals are faulty, repair or replace as necessary. If connector terminals are okay, go to next step.
- Measure voltage between ground and DLC terminal No. 16 (Light Green/Red wire). See Figure. If battery voltage exists, go to next step. If battery voltage does not exist, repair open circuit in Light Green/Red wire between DLC and Central Junction Box. For POWER DISTRIBUTION circuit identification. See WIRING DIAGRAMSΒ .
- Measure resistance between ground and DLC terminals No. 4 (Black wire), then No. 5 (Black/Yellow wire). If both resistance readings are 5 ohms or less, repair or replace WDS or NGS tester. If either resistance reading is more than 5 ohms, repair open in appropriate circuit between ground and DLC. For GROUND DISTRIBUTION circuit identification. See WIRING DIAGRAMSΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
