2002 Ford Taurus LX, 3.0 2, AX4SFACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 2002 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

For module communications network components location, see Fig 1

COMPONENT LOCATIONS

Component Location
Anti-Lock Brake System Control Module Right Front Of Engine Compartment, Behind Radiator
Central Junction Box Behind Left Side Of Instrument Panel
Data Link Connector Under Instrument Panel Between Steering Column And Radio
Generic Electronic Module Behind Instrument Panel, Next To Central Junction Box
In-Line Harness Connector C140 Left Rear Corner Of Engine Compartment
In-Line Harness Connector C144 Right Front Corner Of Engine Compartment
In-Line Harness Connector C134 Behind Right Front Kick Panel
In-Line Harness Connector C314 Behind Left Side Of Instrument Panel, Near "A" Pillar
Powertrain Control Module Behind Right Front Kick Panel
Restraint Control Module Behind Left Center Of Instrument Panel
Fig 1: Locating Electronic Modules & Electronic Cluster
G00162098Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.