Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Disassembly And Assembly: Disassembly
- Remove the steering column (3C529). For additional information, refer to COLUMN .
- Remove the ignition switch (11572).
- Remove the screws.
- Remove the ignition switch.
WARNING:
To avoid risk of serious personal injury, follow all warnings, cautions, notes and instructions
during the driver air bag removal and installation procedure. See AIR BAG RESTRAINT SYSTEMS
article.
CAUTION:
Carefully note the position of the steering column lock gear, bearing and retainer prior to removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.