2002 Ford Focus SVTFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment: Rear

Raise and support the vehicle. Loosen the rear lower arm adjustment cam to the crossmember nut. See Fig 1 . Tighten the nut to 71 INCH lbs. (8 N.m). Lower the vehicle. Bounce the vehicle to make sure that the suspension is in its normal resting position. Rotate the bolt and eccentric washer to achieve the required setting. See WHEEL ALIGNMENT SPECIFICATIONSΒ  . Tighten nut to specification. See TORQUE SPECIFICATIONSΒ  .

Fig 1: Adjusting Rear Toe
G00281136Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.