Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Ford Focus SVTFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application

Ft. Lbs. (N.m)

Brake Caliper Guide Pin Bolt

21 (28)

Crossmember Bolts

⁽¹⁾

Hub Retaining Nut

233 (316)

Knuckle-To-Strut Bolt

66 (89)

Lower Control Arm Ball Joint Bolt

35 (47)

Lower Control Arm Inboard Nut

Step 1

74 (100)

Step 2

Additional 60 degrees

Lower Control Arm Outboard Nut

89 (120)

Lower Control Arm-To-Crossmember Bolt

Step 1

89 (120)

Step 2

Additional 90 degrees

Lower Control Arm-To-Knuckle Pinch Bolt Nut

37 (50)

Stabilizer Bar Clamp Bolts

52 (71)

Stabilizer Bar Link-To-Strut Assembly Nut

37 (50)

Stabilizer Bar-To-Link Nut

37 (50)

Steering Column Shaft Coupling

21 (28)

Strut/String Assembly Thrust Bearing Nut

35 (47)

Strut Upper Mount Nuts

18 (24)

Tie Rod-To-Knuckle Nut

35 (47)

Wheel Lug Nuts

94 (127)

INCH Lbs. (N.m)

ABS Wheel Speed Sensor Bolt

80 (9)

⁽¹⁾	See Figure .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.