Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Focus SVTFACTORY OEM SERVICE PROCEDURE
General Specifications
WARNING: This page is about a different car, the 2003 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Engine (2.0L SPI) General Specifications Chart
| Item | Specification |
|---|---|
| Displacement | 2.0 Liters (121 CD) |
| Number of cylinders | 4 |
| Bore and stroke | 84.8 mm x 88 mm |
| Firing order | 1-3-4-2 |
| Oil pressure (hot 2000 rpm) | 240 kPa -450 kPa |
| Drive belt tension | 178 N-311 N |
| Compression ratio | 9.35:±0.25 |
| Coolant capacity | 5.0-5.8 Liters |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.