Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Focus S2FACTORY OEM SERVICE PROCEDURE
Selector lever cable: Notes
- At the transaxle end the selector lever cable is attached to a ball on the lever on the shift shaft lever through the transmission range (TR) sensor.
- The cable abutments are secured firstly to the transaxle housing and secondly to the bracket of the selector lever.
- The adjuster for the selector lever cable is located at the transaxle side of the sheath.
- At the selector lever end the cable is clipped onto a ball.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.