2002 Ford Focus S2FACTORY OEM SERVICE PROCEDURE

Test D: Generic Electronic Module Does Not Respond To Scan Tool

  1. Turn ignition switch to LOCK position. Disconnect Generic Electronic Module (GEM) connector C104. Measure resistance between GEM connector C104 terminal No. 16 (White/Green wire) and DLC terminal No. 7 (White/Black wire). See Figure and Fig 1 . If resistance is less than 5 ohms, replace GEM and test system operation. If resistance is 5 ohms or more, repair open between C104 and DLC connector. Test system operation.
Fig 1: Identifying Generic Electronic Module Harness Connector C104 Terminals
G00188388Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.