Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Ford Explorer 4.6 W, RWDFACTORY OEM SERVICE PROCEDURE
Warning Devices
WARNING DEVICES DIAGNOSTIC TROUBLE CODES (DTC) IDENTIFICATION
| DTC | Description | Source | Test |
|---|---|---|---|
| B1340 | Chime Input Request Circuit Short to Ground | Instrument Cluster (IC) | Go To PINPOINT TEST E . |
| B1342 | Vehicle Security Module is Defective | Vehicle Security Module | CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved, INSTALL a new vehicle security module. REFER to MULTIFUNCTION ELECTRONIC MODULE . TEST the system for normal operation. |
| B1352 | Ignition Key-In Circuit Failure | Instrument Cluster (IC) | Go To PINPOINT TEST B . |
| B1462 | Safety Belt Switch Circuit Failure | RCM | Go To PINPOINT TEST A . |
| B1577 | Lamp Park Input Short Circuit to Battery | Vehicle Security Module | Go To PINPOINT TEST D . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
