Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Selector Lever Indicator Adjustment
- Remove the two screws and the instrument panel lower steering column opening cover.
- Remove the screws and the instrument panel opening cover reinforcement.
- Rotate the gearshift lever (7210) clockwise until it bottoms out (first gear), then rotate it counterclockwise two detents (D position).
- Hang a 1.4 kg (3.0 lb) weight on the gearshift lever.
- Rotate the thumbwheel to center the selector lever indicator in the middle of the D position.
- Remove the 1.4 kg (3.0 lb) weight.
- Rotate the gearshift lever into each detent to verify that the selector lever indicator matches the selected range. Readjust, if necessary.
- Install the instrument panel opening cover reinforcement.
- Install the instrument panel lower steering column opening cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.