Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Wiper/Washer Systems DTCS
FRONT ELECTRONIC MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1241 | Rear Wiper Washer Pump Relay Circuit Short To Voltage | G |
| B1244 | Rear Wiper Run Relay Circuit Failure | C |
| B1245 | Rear Wiper Run Relay Circuit Short To Voltage | C |
| B1342 | ECU Defective | Clear and document all DTCs. Perform Front Electronic Module (FEM) self-test. If DTC B1342 is retrieved again, replace FEM. Prior to replacement of FEM, it is necessary to upload module configuration information using NGS tester. See FORD MOTOR CO. in COMPUTER RELEARN PROCEDURES article. |
| B1431 | Wiper ON/OFF Relay Circuit Failure | B |
| B1432 | Wiper ON/OFF Relay Circuit Short To Voltage | B |
| B1436 | Wiper Speed Relay Coil Circuit Short To Voltage | H |
| B1438 | Wiper Switch Circuit Failure | B |
| B1446 | Front Wiper Park Sense Circuit Failure | E |
| B1448 | Wiper Park Sense Circuit Short To Voltage | E |
| B1450 | Wiper Wash/Delay Switch Circuit Failure | B |
| B1460 | Wiper Washer Pump Motor Relay Coil Circuit Short To Voltage | G |
| B1482 | Wiper Washer Fluid Level Sensor Circuit Short To Ground | See ANALOG INSTRUMENT PANELS "Low Washer Fluid Warning Indicator Inoperative" M |
| B1611 | Rear Wiper Switch Circuit Failure | C |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
