Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE
Test E: Remote Keyless Entry Module Does Not Respond To NGS Tester
WARNING: This page is about a different car, the 2000 Ford Windstar and 1999 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If repairs to a module communication network circuit is required, see REPAIRING BUS WIRING
. If module replacement is necessary, see PROGRAMMING
and REMOVAL & INSTALLATION
.
- Turn ignition switch to OFF position. Disconnect Remote Keyless Entry (RKE/DDM) module 12-pin harness connector C200. Inspect connector for damage. Repair as necessary. Connect RKE/DDM module 12-pin harness connector. Connect Next Generation Star (NGS) tester to Data Link Connector (DLC). Turn ignition switch to ON position. Perform data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM. If response was RKE (DDM): NO RESPONSE ON CKT914 (BUS+), go to next step. If response was RKE (DDM): NO RESPONSE ON CKT915 (BUS-), go to step 3 .
- Turn ignition switch to OFF position. Disconnect NGS tester. Disconnect RKE/DDM module 12-pin harness connector C200. Measure resistance between RKE/DDM module harness connector C200 terminal No. 3 (Tan/Orange wire) and DLC terminal No. 2 (Tan/Orange wire). If resistance was less than 5 ohms, replace RKE/DDM. If resistance is 5 ohms or more, repair open in Tan/Orange wire between RKE/DDM module and DLC.
- Turn ignition switch to OFF position. Disconnect NGS tester and RKE/DDM module 12-pin harness connector C200. Measure resistance between RKE/DDM module harness connector C200 terminal No. 4 (Pink/Light Blue wire) and DLC terminal No. 10 (Pink/Light Blue wire). If resistance is less than 5 ohms, replace RKE/DDM. If resistance was 5 ohms or more, repair open in Pink/Light Blue wire between RKE/DDM module and DLC.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.