2001 Ford Windstar BaseFACTORY OEM SERVICE PROCEDURE

Spare Key Programming

NOTE: This procedure is used when customer needs extra keys programmed, without erasing stored codes, and 2 programmed keys are not available, but system has 2 ignition keys programmed. A maximum of 8 keys can be programmed. If 8 keys are already programmed, this procedure will not allow any more keys to be programmed. Number of programmed keys can be determined by accessing Virtual Image Cluster (VIC) PID NUMKEYS with New Generation Star (NGS) tester.

Insert unprogrammed key in ignition and turn ignition switch to ON position. Connect New Generation Star (NGS) tester to Data Link Connector (DLC). Insert Ford Service Function (FSF) card in NGS tester. Perform security access procedure. See SECURITY ACCESS PROCEDURE  . Select IGNITION KEY CODE PROGRAM. Turn ignition switch to OFF position. Disconnect NGS tester. Key should now be programmed and be able to start vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.