Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Taurus SELFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| A/C Clutch Diode | In battery junction box. |
| Air Temperature Door Variable Resistor | Behind center of glove box. |
| Blower Motor Resistor Assembly | In dash, below center of glove box. |
| Cellular Phone Antenna | Top center of rear window. |
| Data Link Connector (DLC) | Mounted on dash, below steering column. |
| Daytime Running Lamp (DRL) Resistor | In right side of engine compartment, behind headlight. |
| Engine Cooling Fan Resistor | Near electric cooling fans. |
| Front Blower Motor Resistor Assembly | Behind center of dash, near HVAC control unit. |
| Hands Free Microphone | Left side of windshield header. |
| Horn | Lower left front of engine compartment. |
| Ignition Coil (3.0L 2V) | On left rear of engine. |
| Ignition Coil (3.0L 2V FFV) | On left rear of engine. |
| Ignition Coil (3.0L 4V) | On top of each cylinder. See Figure . |
| Ignition Transformer Capacitor (3.0L 2V) | Attached to ignition coil. |
| Ignition Transformer Capacitor (3.0L 2V FFV) | Attached to ignition coil. |
| Ignition Transformer Capacitor (3.0L 4V) | Part of individual ignition coils. See Figure . |
| Non-Speed Control Jumper | In left rear of engine compartment. |
| Passive Anti-Theft System (PATS) Transceiver | In steering column, near ignition switch. |
| PCM Diode | In central junction box. |
| Photo Cell & Amplifier | On top right side of dash. |
| Power Point | Behind center of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
