Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Explorer ChassisFACTORY OEM SERVICE PROCEDURE
Parking Aid System DTCS
PARKING AID SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) IDENTIFICATION
| DTC | Description | Test |
|---|---|---|
| B1299 | Power Supply Sensor Circuit Short To Ground | A |
| B1342 | ECU Defective | Using scan tool, clear DTCs. Perform Parking Aid Module (PAM) self-test. If DTC B1342 is retrieved again, replace PAM. |
| B2373 | LED #1 Circuit Short To Voltage | B |
| B2477 | Module Configuration Failure | Program Parking Aid Module (PAM). |
| C1699 | Left Rear Sensor Short To Voltage | B |
| C1700 | Left Rear Sensor Circuit Failure | B |
| C1701 | Left Rear Sensor Circuit Fault | B |
| C1702 | Right Rear Sensor Short To Voltage | B |
| C1703 | Right Rear Sensor Circuit Failure | B |
| C1704 | Right Rear Sensor Circuit Fault | B |
| C1705 | Left Rear Center Sensor Circuit Short To Voltage | B |
| C1706 | Left Rear Center Sensor Circuit Failure | B |
| C1707 | Left Rear Center Sensor Fault | B |
| C1708 | Right Rear Center Sensor Circuit Short To Voltage | B |
| C1709 | Right Rear Center Sensor Circuit Failure | B |
| C1710 | Right Rear Center Sensor Fault | B |
| C1742 | Rear Speaker Circuit Failure | B |
| C1743 | Rear Speaker Circuit Short To Voltage | B |
| C1748 | Switch Input Circuit Short To Ground | B |
| C1920 | LED #1 Circuit Failure | B |
| C2373 | LED #1 Circuit Short To Voltage | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
