Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Explorer ChassisFACTORY OEM SERVICE PROCEDURE
A/C-Heater System DTCS: Automatic: EATC
A/C-HEATER SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION (AUTOMATIC - EATC)
| DTC | Description |
|---|---|
| B1249 | Blend Door Actuator Short |
| B1249 | Blend Door Actuator Failure |
| B1251 | In-Car Temp. Sensor Open |
| B1253 | In-Car Temp. Sensor Short |
| B1255 | Ambient Air Temp. Sensor Open |
| B1257 | Ambient Air Temp. Sensor Short |
| B1261 | Sunload Temp. Sensor Short |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.