Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Explorer ChassisFACTORY OEM SERVICE PROCEDURE
Data Link Diagnostic Test
WARNING: This page is about a different car, the 2000 Mercury Mountaineer and 2000 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Connect New Generation Star (NGS) tester to Data Link Connector (DLC), if not already connected. Turn ignition on. Rotate dial on NGS tester to menu item DIAGNOSTIC DATA LINK and press trigger. A test will be performed on the SCP communication network bus and the ISO 9141 communication link.
- If NGS tester displays SYSTEM PASSED, test passed. Repair by symptom. See SYMPTOM TEST INDEX table.
- If NGS tester does not display SYSTEM PASSED, perform the following as applicable:
- If no response from NGS tester, go to TEST M: NO MODULE/NETWORK COMMUNICATION - NO POWER TO NGS TESTER THROUGH DLC under SYSTEM TESTS.
- If NGS tester displays CKT 70, CKT 914 or CKT 915 = SOME ECUS NO RESP/NOT EQUIP, repair by symptom. See SYMPTOM TEST INDEX table.
- If NGS tester displays CKT 70 = ALL ECUS NO RESP/NOT EQUIP, go to TEST K: NO MODULE/NETWORK COMMUNICATION - ISO 9141 NETWORK under SYSTEM TESTS.
- If NGS tester displays CKT 914 = ALL ECUS NO RESP/NOT EQUIP, go to TEST L: NO MODULE/NETWORK COMMUNICATION - SCP NETWORK under SYSTEM TESTS.
- If NGS tester displays CKT 915 = ALL ECUS NO RESP/NOT EQUIP, go to TEST L: NO MODULE/NETWORK COMMUNICATION - SCP NETWORK under SYSTEM TESTS.
- If NGS tester displays NO RESPONSE/NOT EQUIPPED for module in question, repair by symptom. See SYMPTOM TEST INDEX table.
- If NGS tester displays NO RESPONSE ON CKT 914 (BUS +) for module in question, repair by symptom. See SYMPTOM TEST INDEX table.
- If NGS tester displays NO RESPONSE ON CKT 915 (BUS -) for module in question, repair by symptom. See SYMPTOM TEST INDEX table.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
