2001 Ford Explorer ChassisFACTORY OEM SERVICE PROCEDURE

Test C: Restraint Control Module Does Not Respond To NGS Tester

  1. Turn ignition switch to LOCK position. Deactivate air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article. Disconnect Restraint Control Module (RCM) 26-pin harness connector C232. See Figure. Inspect RCM connector for physical damage, bent terminals or corrosion. If connector is okay, go to next step. If connector is damaged, repair connector as necessary and recheck system operation.
  2. Measure resistance of Light Blue/White wire between RCM harness connector C232 terminal No. 5 and Data Link Connector (DLC) terminal No. 7. See Figure and Fig 1 . If resistance is less than 5 ohms, replace RCM and recheck system operation. If resistance is 5 ohms or more, repair open in Light Blue/White wire between RCM and DLC. Recheck system operation.
Fig 1: Identifying Restraint Control Module Harness Connector C232 Terminals
G99C02793Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.