NOTE: Receiver assembly is factory programmed with a permanent 5-digit entry code. Permanent entry code is located on owner's wallet card in glove compartment, can be accessed using scan tool from RAP KEYCODE PID and is attached to receiver assembly housing.

To program a temporary access code, enter 5-digit permanent entry code into keypad. Within 5 seconds, press 1/2 button. Within 5 seconds, enter 5-digit code without exceeding 5 seconds between each button pressed.

To enable or disable autolock using ignition switch, close all doors. Turn ignition switch to LOCK position. Within 30 seconds, perform the following:

Turn ignition switch from OFF to RUN position.
Press power door lock UNLOCK button 3 times.
Turn ignition switch to LOCK position.
Press power door lock UNLOCK button 3 times.
Turn ignition switch to RUN position.

RAP module should chirp horn once to signal enable/disable mode. Press power door lock UNLOCK button once. Horn will chirp once to indicate autolock has been disabled. If horn sounds one short chirp followed by a second longer chirp, autolock has been enabled. Turn ignition OFF to exit enable/disable mode.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Remote Keyless Entry Systems: Programming: Keypad

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?