Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using Ignition Switch
Close all doors. Ensure ignition switch is in OFF position. Within 30 seconds, perform the following steps:
- Turn ignition switch to RUN position.
- Press driver's power door lock UNLOCK button 3 times.
- Turn ignition switch to LOCK position.
- Turn ignition switch to RUN position.
- Horn should chirp, indicating RAP module is in enable/disable mode.
- Press driver's power door lock UNLOCK button once to command autolock feature OFF.
- Press driver's power door LOCK button once to enter command.
RAP module should chirp horn once to confirm autolock has been disabled. If one chirp is heard, followed by a longer sound of horn, autolock has been enabled. To disable, repeat step 7. To exit enable/disable mode, turn ignition switch to LOCK position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.