Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Ford Explorer 4D Utility, 4.0 KFACTORY OEM SERVICE PROCEDURE
Power Windows DTCS
POWER WINDOWS DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description | Test |
|---|---|---|
| B1302 | Accessory Delay Relay Coil Circuit Failure | A |
| B1304 | Accessory Delay Relay Coil Circuit Open Or Short To Voltage | A |
| B1313 | Battery Saver Relay Coil Circuit Failure | A |
| B1315 | Battery Saver Relay Coil Circuit Short To Voltage | A |
| B1342 | GEM Defective | Replace GEM |
| B1398 | Power Window One-Touch Down Relay Circuit Failure | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
| B1400 | Power Window One-Touch Down Relay Coil Circuit Short To Voltage | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
| B1404 | Driver's Door Power Window Down Circuit Open | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
| B1405 | Driver's Door Power Window Down Circuit Short To Power | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
| B1410 | Driver's Door Power Window Motor Circuit Failure | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
| B1475 | Accessory Delay Relay Contacts Short To Voltage | Repair by symptom. See SYMPTOM INDEX table under SYSTEM TESTS . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
