Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Master Switch
Remove master window/door lock switch. See POWER WINDOW SWITCHΒ under REMOVAL & INSTALLATION. Check for continuity between terminals as specified while operating switch. See appropriate MASTER SWITCH TESTING table. See Figure or Figure . If continuity does not exist as specified, replace switch.
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Neutral | 8, 9, 10, 11, 13, 15, 16, 17 & 18 | |
| Left Front | ||
| Up | 8 & 19; 9, 10, 11, 13, 15, 16, 17 & 18 | |
| Down | 10 & 19; 8, 9, 11, 13, 15, 16, 17 & 18 | |
| Right Front | ||
| Up | 9 & 19; 8, 10, 11, 13, 15, 16, 17 & 18 | |
| Down | 11 & 19; 8, 9, 10, 13, 15, 16, 17 & 18 | |
| Left Rear | ||
| Up | 15 & 19; 8, 9, 10, 11, 13, 15, 16 & 18 | |
| Down | 17 & 19; 8, 9, 10, 11, 13, 16, 17 & 18 | |
| Right Rear | ||
| Up | 16 & 19; 8, 9, 10, 11, 13, 15, 17 & 18 | |
| Down | 18 & 19; 8, 9, 10, 11, 13, 15, 16 & 17 | |
| Lockout Unlocked | 19 & 20 | |
| Switch Illumination | 1 & 5; 12 & 14 | |
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Neutral | 1 & 3; 5, 9 & 11; 2, 4, 8 & 12 | |
| Left | ||
| Up | 3 & 5; 1, 9 & 11 | |
| Down | 1 & 3; 5, 9 & 11 | |
| Right | ||
| Up | 10 & 12; 2, 4 & 8 | |
| Down | 8 & 10; 2, 4 & 12 | |
| Switch Illumination | 6 & 7; 13 & 14 | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
