2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Contour & Mystique

  1. Turn ignition switch to RUN position. Locate programming connector located next to electronic door lock module above glove box. Momentarily connect both terminals on programming connector. Horn will sound to verify program mode has been entered successfully. Press any button on remote transmitter.
  2. Horn will sound again to verify remote transmitter has been programmed successfully. To program additional remote transmitters, press any button on next remote transmitter. Horn will sound again to indicate new transmitters have been programmed. Turn ignition switch to LOCK position. Horn will sound again to confirm program mode has exited.
NOTE: After first remote transmitter is programmed, all other remote transmitters will be erased from memory. All remote transmitters must be programmed at the same time. Up to 4 transmitters may be programmed at one time.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.