WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Prior to removal of the RKE module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into a new module once installed. For additional information, refer to MODULE CONFIGURATION .

Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the utility compartment.
1. Remove the four pin-type retainers.
2. Remove the utility compartment.
  - If equipped, disconnect the power point electrical connector.
    
    Fig 1: Removing Utility Compartment
    Courtesy of FORD MOTOR CO.
Disconnect the electrical connector.

Fig 2: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the nuts and the remote keyless entry module.

Fig 3: Removing Nuts And Remote Keyless Entry Module
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Removal and Installation

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?