2000 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Prior to removal of the FEM, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the instrument panel lower steering column opening cover.
    1. Remove the bolts.
    Fig 1: Removing Instrument Panel Lower Steering Column Opening Cover
    G01307380Courtesy of FORD MOTOR CO.
  3. Remove the instrument panel opening cover reinforcement.
    1. Remove the bolts.
      Fig 2: Removing Instrument Panel Opening Cover Reinforcement
      G01307381Courtesy of FORD MOTOR CO.
  4. Remove the front electronic module (FEM).
    1. Disconnect the five electrical connectors.
    2. Remove the three bolts.
      Fig 3: Removing Front Electronic Module (FEM)
      G01307382Courtesy of FORD MOTOR CO.
  5. CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION .
  6. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.